DIP-14 and SOIC-14: 14-Pin IC Pinouts
Logic gates, CMOS parts, quad op-amps and small microcontrollers in 14-pin packages.
The 14-pin package is the home of logic gates. A 74HC00 contains four NAND gates with two inputs and one output each, twelve pins in total, plus two pins for the supply. As DIP-14 it fits a breadboard, and as SOIC-14 it is the SMD version with the same pinout. Pin 1 is marked by a notch or dot, and numbering runs counter-clockwise when viewed from the top.
Almost every 74HC, 74LS and CD4000 part has GND on pin 7 and VCC on pin 14, the two corners opposite pin 1. The rule is so common that it is easy to remember, but it does not hold for every 14-pin part. Quad op-amps such as the LM324, TL074 and MCP6004 put V+ on pin 4 and V− on pin 11, the LM339 comparator has VCC on pin 3 and GND on pin 12, and microcontrollers such as the ATtiny84 have VCC on pin 1 and GND on pin 14.
The analysis below shows how many parts follow the most common layout, and the table shows the supply pins of each device. When mixing logic and op-amps on one board, check the supply of every IC separately.
Overview from the pinout data
21 of 31 parts have GND on pin 7 and the supply on pin 14.
All parts (31)
74HC00 Quad 2-Input NAND Gate
Quad 2-input NAND gate in high-speed CMOS logic. 2–6V supply. Each gate output is the inverted AND of its two inputs. Pin-compatible with 74LS00 and CD4011B.
74HC02 Quad 2-Input NOR Gate
High-speed CMOS quad 2-input NOR gate with output drive capability of 10 LSTTL loads. Operating voltage 2V to 6V.
74HC04 Hex Inverter
Six independent single-input inverter gates in high-speed CMOS logic. 2–6V supply. Each gate output is the logic complement of its input. Pin-compatible with 74LS04.
74HC08 Quad 2-Input AND Gate
High-speed CMOS quad 2-input AND gate. Pin-compatible upgrade to 74LS08 with lower power consumption and wider voltage range (2V to 6V).
74HC08 / 74LS08 Quad 2-Input AND Gate
Quad 2-input AND gate. Available in 74LS (low-power Schottky TTL) and 74HC (high-speed CMOS) families, pin-compatible. Output is HIGH only when both inputs are HIGH.
74HC32 / 74LS32 Quad 2-Input OR Gate
Quad 2-input OR gate. Available in 74LS (low-power Schottky TTL) and 74HC (high-speed CMOS) families, pin-compatible. Output is HIGH when at least one input is HIGH.
74HC86 Quad 2-Input XOR Gate
Quad 2-input exclusive-OR (XOR) gate in high-speed CMOS. 2–6V supply. Output is HIGH when inputs differ. Pin-compatible with 74LS86.
74HC14 Hex Inverting Schmitt Trigger
Six independent Schmitt-trigger inverters in high-speed CMOS. 2–6V supply. Same pin-out as 74HC04 but with hysteresis on each input, making it suitable for noisy or slow-rising signals and oscillator circuits.
74HC125 Quad 3-State Non-Inverting Buffer
Quadruple bus buffer gates with independent active-low output enables (~OE), frequently used for bus multiplexing and SPI chip-select isolation.
74HC74 Dual D-Type Positive-Edge-Triggered Flip-Flop
Dual positive-edge-triggered D-type flip-flop with asynchronous individual set (~PRE) and clear (~CLR) inputs and complementary Q and ~Q outputs.
74HC164 8-Bit Serial-In / Parallel-Out Shift Register
High-speed CMOS 8-bit serial-in parallel-out shift register with two AND-gated serial inputs and asynchronous master reset. No output latch (unlike 74HC595).
74HC393 Dual 4-Bit Binary Ripple Counter
Dual 4-bit binary ripple counter with individual clock (~CP) and master reset (MR) inputs for each 4-bit stage (can be cascaded for 8-bit counting).
CD4001B CMOS Quad 2-Input NOR Gate
Standard CMOS quad 2-input NOR gate with buffered outputs. Wide supply voltage range from 3V to 18V with high noise immunity.
CD4011B Quad 2-Input NAND Gate
Quad 2-input NAND gate in CMOS logic. 3–18V supply. Each gate output is the inverted AND of its two inputs. Pin-compatible with 74HC00.
CD4013B CMOS Dual D-Type Flip-Flop
High-voltage CMOS dual D-type static flip-flop with independent Set, Reset, Clock, and Data inputs operating over a 3V to 18V supply range.
CD4069UB CMOS Hex Unbuffered Inverter
CMOS hex unbuffered inverter constructed with complementary MOS transistors. Single-stage design makes it ideal for linear oscillators, amplifiers, and audio synthesis.
CD40106B CMOS Hex Schmitt-Trigger Inverter
Six independent inverter circuits with Schmitt-trigger input action. The hysteresis provides high noise immunity and clean square-wave outputs from slowly changing analog inputs.
CD4093B Quad 2-Input NAND Schmitt Trigger
CMOS logic integrated circuit consisting of four independent 2-input NAND gates with Schmitt-trigger action on both inputs. Ideal for waveform shaping, noise elimination, astable multivibrators, and monostable pulse generators with wide 3V to 18V operation.
CD4066B Quad Bilateral Analog Switch
Four independent bidirectional analog switches. Each switch passes analog or digital signals in both directions when the control input is HIGH. 3–18V supply, Ron typically 80Ω.
LM324 Low-Power Quad Operational Amplifier
Low-Power, Quad-Operational Amplifiers, DIP-14/SOIC-14/SSOP-14
TL074 Low-Noise JFET-Input Quad Op-Amp
Quad Low-Noise JFET-Input Operational Amplifiers, DIP-14/SOIC-14
MCP6004 1MHz Low-Power Rail-to-Rail Quad Op-Amp
1MHz, Low-Power Op Amp, DIP-14/SOIC-14/TSSOP-14
LM339 Quad Differential Comparator
Quad Differential Comparators, DIP-14/SOIC-14/TSSOP-14
LM556 Dual Precision Timer
Dual Timer, DIP-14/SOIC-14
ICL8038 Precision Waveform Generator / VCO
Monolithic waveform generator capable of generating simultaneous sine, square, triangular, sawtooth and pulse waveforms with minimum external components.
ATtiny84 8-Bit AVR Microcontroller (DIP-14)
20MHz, 8kB Flash, 512B SRAM, 512B EEPROM, debugWIRE, DIP-14
ATtiny1614 8-bit AVR microcontroller
8-bit AVR MCU with 16KB Flash, 2KB SRAM, 256B EEPROM, GPIO on VDD power domain, UPDI programming, crystal and external clock inputs. SOIC-14 package.
MCP2221A USB-to-UART/I2C Converter
USB-to-UART serial converter with I2C master, four multifunction GP pins (GPIO, ADC, DAC, clock, LED), integrated USB termination and oscillator. Supply 3.3V USB.
MCP2518FD CAN FD Controller with SPI Interface
External CAN FD controller with SPI interface, TXCAN/RXCAN to transceiver, oscillator pins, two interrupt/GPIO pins and CLKO/SOF output.
TXB0104PWR 4-bit bidirectional voltage-level translator
4-bit bidirectional voltage-level translator with VCCA (1.2 V to 3.6 V) and VCCB (1.65 V to 5.5 V) supplies, OE tri-state enable. TSSOP-14 (PW) package.
PI4ULS3V204 4-bit Bidirectional Level Translator
4-bit bidirectional voltage level translator. VCCA and VCCB each 1.1 V to 3.6 V. Active-high output enable EN; low places all outputs in 3-state.