Gehäuse

DIP-14 und SOIC-14: Pinouts 14-poliger ICs

Logikgatter, CMOS-Bausteine, Vierfach-OPVs und kleine Mikrocontroller im 14-poligen Gehäuse.

Das 14-polige Gehäuse ist die Heimat der Logikgatter. Ein 74HC00 enthält vier NAND-Gatter mit je zwei Eingängen und einem Ausgang, zusammen zwölf Pins, dazu kommen zwei Pins für die Versorgung. Als DIP-14 passt es ins Steckbrett, als SOIC-14 ist es die SMD-Variante mit gleicher Belegung. Pin 1 ist durch Kerbe oder Punkt markiert, gezählt wird bei Draufsicht gegen den Uhrzeigersinn.

Fast alle 74HC-, 74LS- und CD4000-Bausteine haben GND an Pin 7 und VCC an Pin 14, also an den beiden Ecken gegenüber von Pin 1. Diese Regel ist so verbreitet, dass sie sich gut merken lässt, sie gilt aber nicht für jedes 14-polige Bauteil. Vierfach-OPVs wie LM324, TL074 und MCP6004 legen V+ an Pin 4 und V− an Pin 11, der Komparator LM339 hat VCC an Pin 3 und GND an Pin 12, und Mikrocontroller wie der ATtiny84 haben VCC an Pin 1 und GND an Pin 14.

Die Auswertung unten zeigt, wie viele Bauteile der häufigsten Belegung folgen, die Tabelle die Versorgungspins jedes Bausteins. Wer Logik und OPVs auf einer Platine mischt, sollte die Versorgung jedes ICs einzeln prüfen.

Übersicht aus den Pinout-Daten

21 von 31 Bauteilen haben GND an Pin 7 und die Versorgung an Pin 14.

BauteilHerstellerPinsVersorgungSchnittstellen
74HC00 Quad 2-Input NAND GateTexas Instruments14VCC 14GND 7–
74HC02 Quad 2-Input NOR GateTexas Instruments / Nexperia / onsemi14VCC 14GND 7–
74HC04 Hex InverterTexas Instruments14VCC 14GND 7–
74HC08 Quad 2-Input AND GateTexas Instruments / Nexperia / onsemi14VCC 14GND 7–
74HC08 / 74LS08 Quad 2-Input AND GateTexas Instruments14VCC 14GND 7–
74HC32 / 74LS32 Quad 2-Input OR GateTexas Instruments14VCC 14GND 7–
74HC86 Quad 2-Input XOR GateTexas Instruments14VCC 14GND 7–
74HC14 Hex Inverting Schmitt TriggerTexas Instruments14VCC 14GND 7–
74HC125 Quad 3-State Non-Inverting BufferTexas Instruments / Nexperia14VCC 14GND 7–
74HC74 Dual D-Type Positive-Edge-Triggered Flip-FlopTexas Instruments / Nexperia14VCC 14GND 7–
74HC164 8-Bit Serial-In / Parallel-Out Shift RegisterTexas Instruments / Nexperia / onsemi14VCC 14GND 7–
74HC393 Dual 4-Bit Binary Ripple CounterTexas Instruments / Nexperia14VCC 14GND 7–
CD4001B CMOS Quad 2-Input NOR GateTexas Instruments14VCC 14GND 7–
CD4011B Quad 2-Input NAND GateTexas Instruments / RCA14VCC 14GND 7–
CD4013B CMOS Dual D-Type Flip-FlopTexas Instruments14VCC 14GND 7–
CD4069UB CMOS Hex Unbuffered InverterTexas Instruments14VCC 14GND 7–
CD40106B CMOS Hex Schmitt-Trigger InverterTexas Instruments14VCC 14GND 7–
CD4093B Quad 2-Input NAND Schmitt TriggerTexas Instruments14VCC 14GND 7–
CD4066B Quad Bilateral Analog SwitchTexas Instruments / RCA14VCC 14GND 7–
LM324 Low-Power Quad Operational AmplifierTexas Instruments14VCC 4GND 11–
TL074 Low-Noise JFET-Input Quad Op-AmpTexas Instruments14VCC 4GND 11–
MCP6004 1MHz Low-Power Rail-to-Rail Quad Op-AmpMicrochip Technology14VCC 4GND 11–
LM339 Quad Differential ComparatorTexas Instruments / ON Semi14VCC 3GND 12–
LM556 Dual Precision TimerTexas Instruments14VCC 14GND 7–
ICL8038 Precision Waveform Generator / VCOIntersil14VCC 6GND 11–
ATtiny84 8-Bit AVR Microcontroller (DIP-14)Microchip / Atmel14VCC 1GND 14I2CPWMSPI
ATtiny1614 8-bit AVR microcontrollerMicrochip14VCC 1GND 14–
MCP2221A USB-to-UART/I2C ConverterMicrochip14VCC 1, 11GND 14–
MCP2518FD CAN FD Controller with SPI InterfaceMicrochip14VCC 14GND 7–
TXB0104PWR 4-bit bidirectional voltage-level translatorTexas Instruments14GND 7–
PI4ULS3V204 4-bit Bidirectional Level TranslatorDiodes Inc.14GND 7–

Alle Bauteile (31)

Chip
Texas Instruments

74HC00 Quad 2-Input NAND Gate

Quad 2-input NAND gate in high-speed CMOS logic. 2–6V supply. Each gate output is the inverted AND of its two inputs. Pin-compatible with 74LS00 and CD4011B.

Chip
Texas Instruments / Nexperia / onsemi

74HC02 Quad 2-Input NOR Gate

High-speed CMOS quad 2-input NOR gate with output drive capability of 10 LSTTL loads. Operating voltage 2V to 6V.

Chip
Texas Instruments

74HC04 Hex Inverter

Six independent single-input inverter gates in high-speed CMOS logic. 2–6V supply. Each gate output is the logic complement of its input. Pin-compatible with 74LS04.

Chip
Texas Instruments / Nexperia / onsemi

74HC08 Quad 2-Input AND Gate

High-speed CMOS quad 2-input AND gate. Pin-compatible upgrade to 74LS08 with lower power consumption and wider voltage range (2V to 6V).

Chip
Texas Instruments

74HC08 / 74LS08 Quad 2-Input AND Gate

Quad 2-input AND gate. Available in 74LS (low-power Schottky TTL) and 74HC (high-speed CMOS) families, pin-compatible. Output is HIGH only when both inputs are HIGH.

Chip
Texas Instruments

74HC32 / 74LS32 Quad 2-Input OR Gate

Quad 2-input OR gate. Available in 74LS (low-power Schottky TTL) and 74HC (high-speed CMOS) families, pin-compatible. Output is HIGH when at least one input is HIGH.

Chip
Texas Instruments

74HC86 Quad 2-Input XOR Gate

Quad 2-input exclusive-OR (XOR) gate in high-speed CMOS. 2–6V supply. Output is HIGH when inputs differ. Pin-compatible with 74LS86.

Chip
Texas Instruments

74HC14 Hex Inverting Schmitt Trigger

Six independent Schmitt-trigger inverters in high-speed CMOS. 2–6V supply. Same pin-out as 74HC04 but with hysteresis on each input, making it suitable for noisy or slow-rising signals and oscillator circuits.

Chip
Texas Instruments / Nexperia

74HC125 Quad 3-State Non-Inverting Buffer

Quadruple bus buffer gates with independent active-low output enables (~OE), frequently used for bus multiplexing and SPI chip-select isolation.

Chip
Texas Instruments / Nexperia

74HC74 Dual D-Type Positive-Edge-Triggered Flip-Flop

Dual positive-edge-triggered D-type flip-flop with asynchronous individual set (~PRE) and clear (~CLR) inputs and complementary Q and ~Q outputs.

Chip
Texas Instruments / Nexperia / onsemi

74HC164 8-Bit Serial-In / Parallel-Out Shift Register

High-speed CMOS 8-bit serial-in parallel-out shift register with two AND-gated serial inputs and asynchronous master reset. No output latch (unlike 74HC595).

Chip
Texas Instruments / Nexperia

74HC393 Dual 4-Bit Binary Ripple Counter

Dual 4-bit binary ripple counter with individual clock (~CP) and master reset (MR) inputs for each 4-bit stage (can be cascaded for 8-bit counting).

Chip
Texas Instruments

CD4001B CMOS Quad 2-Input NOR Gate

Standard CMOS quad 2-input NOR gate with buffered outputs. Wide supply voltage range from 3V to 18V with high noise immunity.

Chip
Texas Instruments / RCA

CD4011B Quad 2-Input NAND Gate

Quad 2-input NAND gate in CMOS logic. 3–18V supply. Each gate output is the inverted AND of its two inputs. Pin-compatible with 74HC00.

Chip
Texas Instruments

CD4013B CMOS Dual D-Type Flip-Flop

High-voltage CMOS dual D-type static flip-flop with independent Set, Reset, Clock, and Data inputs operating over a 3V to 18V supply range.

Chip
Texas Instruments

CD4069UB CMOS Hex Unbuffered Inverter

CMOS hex unbuffered inverter constructed with complementary MOS transistors. Single-stage design makes it ideal for linear oscillators, amplifiers, and audio synthesis.

Chip
Texas Instruments

CD40106B CMOS Hex Schmitt-Trigger Inverter

Six independent inverter circuits with Schmitt-trigger input action. The hysteresis provides high noise immunity and clean square-wave outputs from slowly changing analog inputs.

Chip
Texas Instruments

CD4093B Quad 2-Input NAND Schmitt Trigger

CMOS logic integrated circuit consisting of four independent 2-input NAND gates with Schmitt-trigger action on both inputs. Ideal for waveform shaping, noise elimination, astable multivibrators, and monostable pulse generators with wide 3V to 18V operation.

Chip
Texas Instruments / RCA

CD4066B Quad Bilateral Analog Switch

Four independent bidirectional analog switches. Each switch passes analog or digital signals in both directions when the control input is HIGH. 3–18V supply, Ron typically 80Ω.

Chip
Texas Instruments

LM324 Low-Power Quad Operational Amplifier

Low-Power, Quad-Operational Amplifiers, DIP-14/SOIC-14/SSOP-14

Chip
Texas Instruments

TL074 Low-Noise JFET-Input Quad Op-Amp

Quad Low-Noise JFET-Input Operational Amplifiers, DIP-14/SOIC-14

Chip
Microchip Technology

MCP6004 1MHz Low-Power Rail-to-Rail Quad Op-Amp

1MHz, Low-Power Op Amp, DIP-14/SOIC-14/TSSOP-14

Chip
Texas Instruments / ON Semi

LM339 Quad Differential Comparator

Quad Differential Comparators, DIP-14/SOIC-14/TSSOP-14

Chip
Texas Instruments

LM556 Dual Precision Timer

Dual Timer, DIP-14/SOIC-14

Chip
Intersil

ICL8038 Precision Waveform Generator / VCO

Monolithic waveform generator capable of generating simultaneous sine, square, triangular, sawtooth and pulse waveforms with minimum external components.

Chip
Microchip / Atmel

ATtiny84 8-Bit AVR Microcontroller (DIP-14)

20MHz, 8kB Flash, 512B SRAM, 512B EEPROM, debugWIRE, DIP-14

Chip
Microchip

ATtiny1614 8-bit AVR microcontroller

8-bit AVR MCU with 16KB Flash, 2KB SRAM, 256B EEPROM, GPIO on VDD power domain, UPDI programming, crystal and external clock inputs. SOIC-14 package.

Chip
Microchip

MCP2221A USB-to-UART/I2C Converter

USB-to-UART serial converter with I2C master, four multifunction GP pins (GPIO, ADC, DAC, clock, LED), integrated USB termination and oscillator. Supply 3.3V USB.

Chip
Microchip

MCP2518FD CAN FD Controller with SPI Interface

External CAN FD controller with SPI interface, TXCAN/RXCAN to transceiver, oscillator pins, two interrupt/GPIO pins and CLKO/SOF output.

Chip
Texas Instruments

TXB0104PWR 4-bit bidirectional voltage-level translator

4-bit bidirectional voltage-level translator with VCCA (1.2 V to 3.6 V) and VCCB (1.65 V to 5.5 V) supplies, OE tri-state enable. TSSOP-14 (PW) package.

Chip
Diodes Inc.

PI4ULS3V204 4-bit Bidirectional Level Translator

4-bit bidirectional voltage level translator. VCCA and VCCB each 1.1 V to 3.6 V. Active-high output enable EN; low places all outputs in 3-state.