DIP-16 und SOIC-16: Pinouts 16-poliger ICs
Schieberegister, Decoder, Zähler, Motortreiber, Schnittstellen und Wandler im 16-poligen Gehäuse.
Im 16-poligen Gehäuse stecken viele Bausteine, die in Mikrocontroller-Projekten ständig gebraucht werden: das Schieberegister 74HC595 für zusätzliche Ausgänge, der Decoder 74HC138, der analoge Multiplexer 74HC4051, die Zähler der CD4000-Reihe, der Motortreiber L293D, das Darlington-Array ULN2003A, der RS-232-Wandler MAX232, der USB-UART-Wandler CH340G und der ADC MCP3008. Die SOIC-16-Variante hat dieselbe Belegung wie das DIP-16.
Bei der Logik gilt wieder eine feste Regel: GND an Pin 8, VCC an Pin 16. Der 74HC595 folgt ihr ebenso wie die CD4000-Zähler, die Multiplexer und die I2C-Expander PCF8574 und TCA9534. Andere Bauteile weichen ab: Der L293D führt die Masse über die vier mittleren Pins 4, 5, 12 und 13 ab, die gleichzeitig als Kühlfläche dienen, und hat zwei Versorgungen für Logik und Motoren. Der ULN2003A hat gar keinen VCC-Pin, sondern nur einen gemeinsamen Anschluss COM für die Freilaufdioden.
Die Auswertung unten zeigt, wie viele Bauteile der häufigsten Belegung folgen, die Tabelle Versorgungspins und Schnittstellen jedes Bausteins.
Übersicht aus den Pinout-Daten
20 von 45 Bauteilen haben GND an Pin 8 und die Versorgung an Pin 16.
Alle Bauteile (45)
74HC595 8-Bit Serial-In / Parallel-Out Shift Register
8-bit serial-input / parallel-output shift register with 3-state outputs. Data is clocked in serially on SRCLK, then latched to the output pins on a rising edge of RCLK. Commonly chained for expanding digital outputs over SPI.
MC74HC595A 8-Bit Shift Register with Latch
8-bit serial-in, parallel-out shift register with storage latch and tri-state outputs. Serial data output SQH for cascading. Logic supply VCC on pin 16, GND on pin 8.
74HC165 8-Bit Parallel-In / Serial-Out Shift Register
8-bit parallel-load shift register. Pull ~PL LOW to latch parallel inputs D0–D7; then clock out serially via Q7 (or its complement ~Q7). ~CE (clock enable, Active Low) gates the clock. Commonly chained for reading multiple buttons or sensors over SPI.
74HC138 3-to-8 Line Decoder / Demultiplexer
3-to-8 line decoder with active-low outputs. Three enable inputs (two active-low ~G2A/~G2B, one active-high G1) allow easy cascading. Complement of 74HC238 (active-high outputs).
74HC139 Dual 2-to-4 Line Decoder/Demultiplexer
High-speed silicon-gate CMOS dual 2-to-4 line decoder/demultiplexer. Features active-low enable inputs and active-low decoded outputs. Ideal for memory address decoding.
74HC238 3-to-8 Line Decoder / Demultiplexer
High-speed 3-to-8 line decoder/demultiplexer with active-high outputs (complement of 74HC138) and three enable inputs (two active-low and one active-high).
74HC151 8-Input Data Selector / Multiplexer
High-speed silicon-gate CMOS 8-channel data selector/multiplexer. Decodes 3 binary address inputs (S0, S1, S2) to select one of eight data sources (D0 through D7) with complementary true (Y) and inverted (~W) outputs.
74HC153 Dual 4-to-1 Line Data Selector/Multiplexer
Dual 4-line to 1-line data selector/multiplexer with common select inputs and separate active-low enable inputs for each section.
74HC157 Quad 2-Line to 1-Line Data Selector/Multiplexer
Quad 2-line to 1-line multiplexer with non-inverting outputs, common select input, and common active-low strobe/enable.
74HC161 Synchronous 4-Bit Binary Counter (Asynchronous Clear)
Synchronous presettable 4-bit binary counter with asynchronous master reset, look-ahead carry outputs, and synchronous parallel loading.
74HC193 Synchronous 4-Bit Binary Up/Down Counter
Synchronous 4-bit reversible up/down binary counter with separate Count-Up and Count-Down clocks, asynchronous parallel load (~PL), asynchronous master reset (MR), and cascade outputs.
74HC4051 8-Channel Analog Multiplexer / Demultiplexer
Single 8-channel bidirectional analog switch (multiplexer/demultiplexer). Address pins S0/S1/S2 select one of 8 channels (Y0–Y7) to connect to the common I/O (Z). ~E disables all switches. VEE allows bipolar analog signals; tie to GND for 0–5V operation.
74HC4052 Dual 4-Channel Analog Multiplexer / Demultiplexer
Dual 4-channel analog multiplexer/demultiplexer with common channel select logic and active-low enable. Supports bidirectional signal routing of digital and analog voltages up to 10V with low ON resistance and break-before-make switching.
74HC4053 Triple 2-Channel Analog Multiplexer / Demultiplexer
Triple 2-channel analog multiplexer/demultiplexer (three independent SPDT analog switches) with three separate digital select inputs and a common enable input. Designed for analog and digital signal switching up to 10V peak-to-peak.
CD4017B Decade Counter with 10 Decoded Outputs
5-stage Johnson counter with 10 decoded outputs. Advances on rising clock edge. 3–18V supply. Used in LED chasers, sequencers, and frequency dividers.
CD4020B CMOS 14-Stage Binary Ripple Counter
14-stage binary ripple counter with master reset. Outputs available from stages 1 and 4 through 14 (stages 2 and 3 are not pinned out). Suitable for long-delay timers.
CD4026B Decade Counter with 7-Segment Output
5-stage Johnson decade counter and an output decoder that converts Johnson code to 7-segment decoded outputs (a through g) capable of driving common-cathode numeric LED displays directly without external decoders.
CD4040B CMOS 12-Stage Binary Ripple Counter
12-stage binary ripple counter with master reset. Advances one count on the negative-going transition of each clock pulse. Common for frequency dividers and timers.
CD4046B CMOS Micropower Phase-Locked Loop (PLL)
Micropower phase-locked loop consisting of a linear voltage-controlled oscillator (VCO) and two different phase comparators with common signal-input and comparator-input.
CD4050B CMOS Hex Non-Inverting Buffer / Converter
Hex non-inverting buffer intended for logic-level conversion. Allowed to have input signal voltages up to 15V exceeding the supply voltage (e.g. 5V to 3.3V translation).
CD4060B CMOS 14-Stage Binary Ripple Counter with Oscillator
14-stage ripple-carry binary counter/divider and oscillator with built-in RC/crystal oscillator section, capable of high-ratio frequency division and long timing delays.
L293 Quadruple Half-H Drivers
Quadruple Half-H motor driver IC providing four independently controlled half-bridge outputs rated 600mA each; no internal flyback diodes (add external diodes for inductive loads).
L293D Quadruple Half-H Drivers with Internal Flyback Diodes
Quadruple Half-H motor driver IC with internal flyback protection diodes, providing four independently controlled half-bridge outputs rated 600mA each. The D suffix indicates built-in suppression diodes, no external diodes needed for inductive loads.
SN754410 Quadruple Half-H Motor Driver
Quadruple high-current half-H driver designed to provide bidirectional drive currents of up to 1A at voltages from 4.5V to 36V. Pin-compatible higher-current modern alternative to the popular L293D with internal output clamp diodes for inductive transient suppression.
ULN2003A High-Voltage High-Current Darlington Transistor Array
High Voltage, High Current Darlington Transistor Arrays, SOIC16/SOIC16W/DIP16/TSSOP16
MAX232 Dual EIA-232 Driver/Receiver with Charge Pump
Dual RS232 driver/receiver, 5V supply, 120kb/s, 0C-70C
MAX3232 3.0V-5.5V Dual RS-232 Transceiver
Two-channel line driver and receiver with ±15-kV ESD protection and internal charge pump for 3.0V to 5.5V operation. Meets EIA/TIA-232-F standards while operating directly from 3.3V microcontroller logic without external high voltage supplies.
CH340G USB to Serial UART Bridge Controller
USB serial converter, UART, SOIC-16
CH340C USB to serial UART bridge
USB to UART bridge with MODEM control signals (RTS#, DTR#, DSR#, DCD#, RI#, CTS#), built-in oscillator interface, 3.3V/5V supply options, SOP-16 package.
FT230XS-R USB to Basic UART IC
USB to basic UART bridge IC in 16-pin SSOP. VCC 5V or 3V3, VCCIO 1V8-3V3 for IO, 3V3 output at 50mA, reset and configurable CBUS I/O pins.
MCP3008 8-Channel 10-Bit ADC with SPI Interface
Popular 8-channel 10-bit analog-to-digital converter (ADC) with SPI serial interface, 200 ksps sampling rate at 5V, and programmable pseudo-differential inputs.
PCF8574 Remote 8-Bit I/O Expander for I2C Bus
General-purpose 8-bit quasi-bidirectional I/O expander for the two-line bidirectional I2C-bus with open-drain interrupt output, widely used in HD44780 LCD I2C backpacks.
PCF8591 8-Bit 4-Channel ADC and 1-Channel DAC (I2C)
Single-chip, single-supply low-power 8-bit data acquisition device with four analog inputs, one analog output (DAC), and an I2C-bus interface.
TCA9534 8-bit I2C-bus and SMBus I/O expander
Low-voltage 8-bit I2C/SMBus I/O expander with interrupt output, 3 address pins and push-pull P-port I/O, 16-pin TSSOP package.
DS3231 Extremely Accurate I2C Integrated RTC/TCXO/Crystal
Extremely Accurate I2C-Integrated RTC/TCXO/Crystal SOIC-16
DAC0808 8-Bit Multiplying D/A Converter
Classic 8-bit monolithic digital-to-analog converter featuring high speed multiplying capability (150ns settling time) and direct interface with TTL, DTL, and CMOS logic.
ADS1220 24-bit 2-kSPS 4-channel delta-sigma ADC with PGA
24-bit, 2 kSPS, 4-channel delta-sigma ADC with low-noise PGA (gain up to 128), SPI interface, excitation current sources, temperature sensor and internal/external clock.
ADG1408 8:1 analog multiplexer
ADG1408 8-channel analog multiplexer, single drain D, 3-bit address A0-A2 with active high enable EN, dual or single supply operation (VSS/VDD).
TL494 Pulse-Width-Modulation Control Circuit
Fixed-frequency pulse-width-modulation (PWM) control circuit designed primarily for power supply control. Incorporates two error amplifiers, an on-chip adjustable oscillator, dead-time control (DTC) comparator, pulse-steering flip-flop, 5.0V precision regulator, and output control circuits.
XR-2206 Monolithic Function Generator IC
Monolithic function generator IC capable of producing high-quality sine, square, triangle, ramp, and pulse waveforms of high-stability and accuracy from 0.01 Hz to over 1 MHz.
PT2399 CMOS Echo / Delay Audio Processor
Single-chip CMOS echo and audio delay processor utilizing internal 44Kbit digital RAM with integrated ADC, DAC, and operational amplifiers. Widely used in guitar pedals, synthesizers, and karaoke equipment.
TEA2025B Stereo Audio Power Amplifier
Monolithic dual audio power amplifier designed for portable radio cassette players and multimedia desktop speakers. Delivers 2.3W per channel in stereo or 4.7W in Bridge-Tied Load (BTL) configuration.
Winbond W25Q128JWF (SOIC-16)
1.8V 128M-bit (16M-byte) Serial NOR Flash memory with Dual/Quad SPI in 16-pin SOIC 300-mil package. Standard IQ series with factory-fixed Quad Enable (QE=1), dedicated hardware /RESET pin on Pin 3, and JEDEC ID 6018h.
Winbond W25Q256JWF (SOIC-16)
1.8V 256M-bit (32M-byte) Serial NOR Flash memory with Dual/Quad SPI in 16-pin SOIC 300-mil package. Standard IQ series with factory-fixed Quad Enable (QE=1), dedicated hardware /RESET input (Pin 3), and JEDEC ID 6019h.
Macronix MX25L25645G (SOP-16)
3V 256M-bit (32M-byte) CMOS MXSMIO Multi-I/O Serial NOR Flash in 16-pin SOP 300-mil package. Features a dedicated hardware RESET# input on Pin 3 and NC/SIO3 on Pin 1.