The Interactive Database for
Pinouts & Hardware Diagrams.

Interactive diagrams, pin functions and links to technical datasheets for microcontrollers, dev boards, and ICs at a glance.

377+ components available

All Boards, Chips & Connectors

Development platforms, microcontrollers, ICs and standard interfaces

Connector
USB Implementers Forum (USB-IF)

Micro-USB 3.0 Type-B (10-Pin)

10-pin SuperSpeed USB 3.0 Micro-B connector combining a standard 5-pin USB 2.0 section with an additional 5-pin SuperSpeed section, commonly found on portable external hard drives.

Connector
VESA (Video Electronics Standards Association)

Mini DisplayPort (mDP) 20-Pin Interface

Miniaturized 20-pin DisplayPort connector introduced by Apple and later standardized by VESA, electrically identical to full-size DisplayPort and reused as the physical connector for Thunderbolt 1 and 2.

Connector
USB-IF (USB Implementers Forum)

Mini-USB Type-B 5-Pin Interface

Compact 5-pin USB 2.0 connector commonly found on older digital cameras, GPS devices, MP3 players, and game controllers. Succeeded by Micro-USB.

Chip
NXP Semiconductors

PCF8563 Real-Time Clock/Calendar

Low-power CMOS Real-Time Clock/Calendar with I2C interface, programmable clock output, alarm and timer functions, backed by a 32.768kHz crystal oscillator.

Chip
NXP Semiconductors

PCF8575 16-Bit I2C I/O Expander

Remote 16-bit I2C-bus general purpose parallel input/output expander with interrupt output, offering quasi-bidirectional I/O across two 8-bit ports (P0, P1), the 16-bit sibling of the PCF8574.

Connector
PCI-SIG (Molex Mini-Fit Jr. Style)

PCIe 6-Pin GPU Power Connector

6-pin auxiliary power connector defined by the PCI Express Power Supply Specification, supplying up to 75W (3x +12V, 3x GND) to graphics cards in addition to the PCIe slot's own 75W.

Connector
IBM / DIN

PS/2 (Mini-DIN 6) Keyboard/Mouse Connector

6-pin Mini-DIN connector introduced with the IBM PS/2 for keyboard and mouse interfaces. Uses synchronous serial protocol with clock and data lines. Purple = keyboard, green = mouse.

Connector
Centronics / IEEE 1284

Parallel Port (DB-25 / LPT Interface)

Standard 25-pin D-Sub parallel interface for printers and peripherals. Pin 1 is Strobe, pins 2–9 are bidirectional 8-bit data lines (SPP/EPP/ECP modes), pins 10–13 and 15 are status inputs, pins 14/16/17 are control outputs, and pins 18–25 are signal ground.

Connector
Radio Corporation of America (RCA)

RCA (Phono) Composite Connector

Single-conductor friction-fit coaxial connector, colour-coded yellow for composite video or red/white for stereo analog audio, ubiquitous on consumer AV equipment.

Connector
TIA / EIA (Telecommunications Industry Association)

RJ11 6P4C Modular Connector (Telephone)

6-position 4-contact modular connector used for analog telephone lines, DSL connections, and fax machines. Smaller than RJ45 with 6mm width.

Chip
Sensirion AG

SHT31-D Digital Temperature & Humidity Sensor

High-accuracy, fully calibrated digital I2C temperature and humidity sensor with two selectable addresses and an ALERT pin for humidity/temperature threshold monitoring.

Chip
Texas Instruments

TCA9548A 8-Channel I2C Multiplexer

8-channel bidirectional I2C/SMBus switch with reset, used to resolve address conflicts between identical I2C sensor breakouts by isolating each device on its own sub-bus.

Chip
onsemi / ST / Fairchild

TIP120 NPN Darlington Transistor

NPN Darlington pair power transistor with integrated base-emitter resistor and flyback diode. Max 60V VCE, 5A IC, hFE min 1000. Ideal for motor and relay driving.

Chip
Texas Instruments

TLC5940 16-Channel LED Driver with Dot Correction

16-channel constant-current LED driver with 12-bit PWM grayscale control and 6-bit dot correction per channel. Supports daisy-chaining via serial interface for large LED arrays.

Chip
Winbond Electronics

W25Q32JV 32Mbit SPI NOR Flash Memory

3V, 32M-bit (4M-byte) Serial NOR Flash memory with dual/quad SPI, used for external firmware/data storage on ESP32, Arduino and FPGA boards.

Frequently Asked Questions & Transparency

Helpful information about data sources, usage, and privacy

Where does the pinout data and technical specification come from?

The pinout data and technical specifications are based on official manufacturer datasheets as well as publicly available documentation and community resources. As PinoutDatabase is an independent project maintained by me as an individual, I strive for high accuracy, though inadvertent mistakes can still happen.

Can I use the graphics and how are they created?

The SVG vector files and PNG graphics are free to download and use for private/personal purposes. Depending on the component, the diagrams are either crafted manually or generated automatically based on package footprint and pin definitions.

Found an error or missing a component? How can I give feedback?

Community feedback is always appreciated! If you spot an error or are missing a specific component, please use the 'Report Issue' button directly on that component's page or send me a message via the contact form.

Is the site free to use and how is privacy handled?

Currently, using PinoutDatabase is completely free and requires no registration. All interactive web tools run entirely client-side inside your browser. Detailed information regarding data processing can be found directly on our Privacy Policy page.