The Interactive Database for
Pinouts & Hardware Diagrams.

Interactive diagrams, pin functions and links to technical datasheets for microcontrollers, dev boards, and ICs at a glance.

377+ components available

All Boards, Chips & Connectors

Development platforms, microcontrollers, ICs and standard interfaces

Chip
Texas Instruments

BQ24074 LiPo Charger with Power Path Management

Single-cell Li-Ion/LiPo linear charger with autonomous power-path management, allowing the system to run directly from USB/DC input while simultaneously charging the battery.

Chip
Texas Instruments / NXP

CD74HC4067 16-Channel Analog Multiplexer/Demultiplexer

High-speed CMOS 16-channel analog multiplexer/demultiplexer with low on-resistance (typ. 70 Ohm) and wide analog voltage range. Ideal for data acquisition and signal routing.

Connector
Generic / CUI Devices (PJ-002A Standard)

DC Barrel Power Jack (5.5x2.1mm)

Standard coaxial DC power jack (5.5mm outer / 2.1mm inner diameter, center-positive) used to supply external power to boards and adapters. Common breadboard-mount versions add a third normally-closed switch contact for power-source detection.

Connector
MIDI Manufacturers Association (MMA) / DIN

DIN-5 (180) MIDI Connector

5-pin 180-degree DIN connector used for MIDI (Musical Instrument Digital Interface) communication at 31.25 kBaud. Only pins 2, 4, 5 are used for MIDI; pins 1, 3 reserved.

Connector
DDWG (Digital Display Working Group)

DVI-D Dual Link Digital Video Connector

Dual-link DVI-D connector with all 24 digital signal pins populated for two TMDS links. Supports resolutions up to 2560x1600 at 60Hz by doubling the available bandwidth.

Connector
DDWG (Digital Display Working Group)

DVI-D Single Link Digital Video Connector

Digital-only DVI connector with 24 signal pins plus 1 ground blade for single-link TMDS signaling. Supports resolutions up to 1920x1200 at 60Hz (single link) or 2560x1600 (dual link).

Connector
DDWG (Digital Display Working Group)

DVI-I Dual Link Integrated (Digital + Analog) Video Connector

Full-featured 29-pin DVI connector with dual TMDS links and analog VGA signals. Supports digital resolutions up to 2560x1600 at 60Hz and analog VGA via passive adapter.

Connector
DDWG (Digital Display Working Group)

DVI-I Single Link Integrated (Digital + Analog) Video Connector

Integrated DVI connector carrying both digital TMDS and analog VGA signals. 24 digital pins plus 5 analog pins (4 analog contacts + 1 ground blade). Supports single-link resolutions up to 1920x1200 at 60Hz.

Connector
AMP / 3M (ATA/ATAPI-4 Standard)

IDC 40-Pin ATA/IDE Ribbon Header

40-pin insulation-displacement (IDC) header for Parallel ATA (PATA/IDE) ribbon cables, carrying a 16-bit data bus and control signals between the host controller and hard disk / optical drives.

Chip
Texas Instruments

INA226 Precision Current/Power Monitor

Bidirectional current, voltage, and power monitor with I2C/SMBus interface and a programmable alert pin, offering higher resolution and accuracy than the popular INA219.

Chip
Infineon / International Rectifier

IRF3205 55V Single N-Channel HEXFET Power MOSFET

High-current N-channel HEXFET Power MOSFET with extremely low on-resistance (8 mOhm typ.) for high-efficiency switching. 55V VDSS, 110A continuous drain current.

Connector
JST (Japan Solderless Terminal Mfg. Co.)

JST-PH 2-Pin Battery Connector (2.0mm Pitch)

2.0mm pitch, 2-position wire-to-board connector, the de-facto standard for single-cell LiPo/Li-Ion battery packs on hobbyist electronics and charge modules such as the TP4056.

Chip
Texas Instruments / National Semiconductor

LM3914 Dot/Bar Display Driver

Monolithic IC that senses analog voltage levels and drives 10 LEDs in a linear dot or bar graph display. Internal voltage reference and precision voltage divider included.

Chip
Maxim Integrated (Analog Devices)

MAX98357A I2S Class-D Mono Amplifier

3W Class-D mono audio amplifier with a digital I2S/PDM input and integrated DAC, requiring no analog audio input, commonly paired with the ESP32/Raspberry Pi for I2S speaker output.

Connector
HDMI Forum / HDMI Licensing Administrator

Micro HDMI (Type D) 19-Pin Interface

Miniaturized 19-pin HDMI connector (Type D) with the same electrical signal assignment as HDMI Type-A, used on cameras, tablets, and single-board computers like the Raspberry Pi Zero and Pi 4.

Frequently Asked Questions & Transparency

Helpful information about data sources, usage, and privacy

Where does the pinout data and technical specification come from?

The pinout data and technical specifications are based on official manufacturer datasheets as well as publicly available documentation and community resources. As PinoutDatabase is an independent project maintained by me as an individual, I strive for high accuracy, though inadvertent mistakes can still happen.

Can I use the graphics and how are they created?

The SVG vector files and PNG graphics are free to download and use for private/personal purposes. Depending on the component, the diagrams are either crafted manually or generated automatically based on package footprint and pin definitions.

Found an error or missing a component? How can I give feedback?

Community feedback is always appreciated! If you spot an error or are missing a specific component, please use the 'Report Issue' button directly on that component's page or send me a message via the contact form.

Is the site free to use and how is privacy handled?

Currently, using PinoutDatabase is completely free and requires no registration. All interactive web tools run entirely client-side inside your browser. Detailed information regarding data processing can be found directly on our Privacy Policy page.