EEPROM: Serial I2C and SPI Memory Pinouts
Small non-volatile memories for settings, calibration data and serial numbers.
Serial EEPROMs keep small amounts of data permanently, such as settings, calibration values, counters or MAC addresses. Unlike flash, they can be written byte by byte and typically endure a million write cycles. Most types sit on the I2C bus, while some such as the 25LC256 use SPI. FRAM devices such as the MB85RS64V share the same pinout but write without delay and almost without limit.
The 8-pin I2C layout is nearly identical across manufacturers: pins 1 to 3 are the address inputs A0 to A2, pin 4 is GND, pin 5 SDA, pin 6 SCL, pin 7 write protect (WP) and pin 8 VCC. A0 to A2 allow up to eight identical memories on one bus. On small types such as the 24LC16 the address pins are not connected internally, because the chip uses those address bits for its own memory blocks.
The SPI types use the same positions for GND and VCC but replace the address pins with chip select, data output and hold. The table shows package, supply and interface of every device; tie the WP pin to GND to allow writes.
Overview from the pinout data
6 of 7 parts have GND on pin 4 and the supply on pin 8.
| Part | Manufacturer | Package | Pins | Pin order / Supply | Interfaces |
|---|---|---|---|---|---|
| 24LC16B 16Kb I2C Serial EEPROM | Microchip Technology | 8-Pin DIP / SOIC | 8 | VCC 8GND 4 | I2C |
| 24LC256 256Kb I2C Compatible 2-Wire Serial EEPROM | Microchip Technology | 8-Pin DIP / SOIC | 8 | VCC 8GND 4 | I2C |
| AT24C32 32-Kbit I2C Serial EEPROM | Microchip / Atmel | 8-Pin DIP / SOIC | 8 | VCC 8GND 4 | I2C |
| AT24C256C I2C Serial EEPROM 256Kbit | Microchip | 8-Pin DIP / SOIC | 8 | VCC 8GND 4 | – |
| 24AA02E48 I2C Serial EEPROM | Microchip | SOT-23-5 | 5 | 1 · SCL2 · VSS3 · SDA4 · VCC5 · NC | – |
| 25LC256 / 25LCxxx SPI Serial EEPROM Family | Microchip Technology | 8-Pin DIP / SOIC | 8 | VCC 8GND 4 | SPI |
| MB85RS64V Serial FeRAM Memory with SPI Interface | RAMXEED (Fujitsu) | 8-Pin DIP / SOIC | 8 | VCC 8GND 4 | – |
All parts (7)
24LC16B 16Kb I2C Serial EEPROM
I2C Serial EEPROM, 16Kb (2048 x 8), 2.5–5.5V, DIP-8/SOIC-8/TSSOP-8. Address pins A0–A2 are No Connect (NC), block addressing is handled internally via the I2C address byte.
24LC256 256Kb I2C Compatible 2-Wire Serial EEPROM
I2C Serial EEPROM, 256Kb (32768 x 8), 2.5–5.5V, DIP-8/SOIC-8/TSSOP-8/DFN-8. Up to 8 devices on one bus via A0–A2 address pins.
AT24C32 32-Kbit I2C Serial EEPROM
32-Kbit (4096 x 8) serial I2C EEPROM with hardware write protection, 32-byte page write, and 1 million write endurance. Commonly paired with DS3231 RTC modules.
AT24C256C I2C Serial EEPROM 256Kbit
256-Kbit two-wire serial EEPROM, 32,768 x 8, I2C interface, 1.7V to 5.5V (Grade 3) or 2.5V to 5.5V (Grade 1), hardware write-protect, 3 address inputs.
24AA02E48 I2C Serial EEPROM
2-wire I2C serial EEPROM, 1.7V to 5.5V supply. Open-drain SDA bidirectional data pin requires pull-up to VCC; SCL serial clock input.
25LC256 / 25LCxxx SPI Serial EEPROM Family
SPI Serial EEPROM family (25LC010A–25LC1024), 1.8–5.5V, DIP-8/SOIC-8/TSSOP-8. Pinout identical across the family.
MB85RS64V Serial FeRAM Memory with SPI Interface
Serial FeRAM memory with SPI-compatible interface (CS, SCK, SI, SO), write protect and hold pins. 8-pin plastic SOP 150mil package.