Pinouts &amp; Pin-Belegungen für Module &amp; Breakouts.

Raspberry Pi Compute Module 5 (CM5 / CM5Lite)

High-performance System-on-Module powered by Broadcom BCM2712 quad-core Cortex-A76 @ 2.4GHz and RP1 I/O controller, up to 16GB LPDDR4x-4267, optional eMMC, PCIe Gen2 x1, Gigabit Ethernet, dual 4Kp60 HDMI, dual 4-lane MIPI, dual USB 3.0 via two 100-pin Hirose DF40 connectors.

Raspberry Pi Compute Module 4 (CM4 / CM4Lite)

System-on-Module powered by Broadcom BCM2711 quad-core Cortex-A72 @ 1.5GHz, up to 8GB LPDDR4, optional eMMC, PCIe Gen2 x1, Gigabit Ethernet, dual HDMI 4Kp60, via two 100-pin Hirose DF40 board-to-board connectors.

SGeT e.V.

SMARC 2.2 Computer-on-Module Pinout

Standardized 314-pin edge connector pinout specification for Smart Mobility ARChitecture (SMARC 2.2) Computer-on-Modules (82x50mm & 82x80mm). Defines LVDS/eDP/DSI, HDMI/DP++, 4x PCIe, 2x GBE, 6x USB 2.0/3.2, 4x MIPI-CSI, SATA, SPI/eSPI/QSPI, audio, serial and power management signals.

Raspberry Pi Compute Module 3+ (CM3+ / CM3 / CM1)

Standard DDR2-SODIMM 200-pin System on Module powered by Broadcom BCM2837B0 64-bit quad-core Cortex-A53 @ 1.2GHz, 1GB LPDDR2 RAM, and optional 8GB/16GB/32GB eMMC Flash (or Lite). Pin-compatible with CM1 and CM3.

Raspberry Pi Compute Module 4S (CM4S)

Drop-in upgrade for CM1/CM3/CM3+ SODIMM carrier boards featuring the Raspberry Pi 4 BCM2711 quad-core Cortex-A72 @ 1.5GHz processor, up to 8GB LPDDR4-3200 SDRAM, and eMMC in the 200-pin SODIMM form factor.

Raspberry Pi Compute Module Zero (CM0 / CM0Lite)

Compact 39mm x 33mm System-on-Module based on Raspberry Pi Zero 2 W with RP3A0 SiP (quad-core 64-bit BCM2837 @ 1GHz, 512MB LPDDR2, optional 8GB/16GB eMMC or Lite) featuring 132 castellated edge pins at 1mm pitch.

Espressif Systems / Ai-Thinker

ESP8266 ESP-01 / ESP-01S Wi-Fi Module

Ultra-compact 2.4 GHz Wi-Fi module with integrated TCP/IP stack, 32-bit Tensilica MCU, and 2x4 (8-pin) 2.54mm pitch header.

NXP Semiconductors / Generic

RC522 13.56 MHz RFID / NFC Reader Module (MFRC522)

Popular contactless 13.56 MHz RFID reader/writer module based on the MFRC522 IC, supporting ISO/IEC 14443 A / MIFARE cards via SPI interface.

Hitachi / Generic

HD44780 1602 / 2004 Character LCD Interface

Industry standard 16-pin interface for dot-matrix alphanumeric LCD modules (16x2, 20x4) based on the Hitachi HD44780 controller, supporting 4-bit and 8-bit parallel modes.

Solomon Systech / Generic

SSD1306 0.96" I2C / SPI OLED Display Module

Standard monochrome 128x64 dot matrix OLED display module driven by the SSD1306 controller with built-in charge pump and support for 4-pin I2C and 7-pin SPI pinouts.

Nordic Semiconductor

nRF24L01+ 2.4GHz Wireless Transceiver Module

Ultra low-power 2Mbps 2.4 GHz RF transceiver with Enhanced ShockBurst hardware protocol accelerator and 2x4 (8-pin) male header.

Texas Instruments

ADS1115 16-Bit 4-Channel Precision ADC Module

Ultra-small, low-power 16-bit precision Analog-to-Digital Converter with internal reference, oscillator, programmable gain amplifier (PGA), and I2C interface.

Allegro MicroSystems / Pololu

A4988 DMOS Stepper Motor Driver (StepStick)

Complete microstepping motor driver with built-in translator, adjustable current limiting, over-current and over-temperature protection, and 5 step resolutions down to 1/16-step.

Texas Instruments / Pololu

DRV8825 Stepper Motor Controller (StepStick)

High-current microstepping bipolar stepper driver with built-in indexing translator, supporting up to 2.5A peak per coil, 45V motor supply, and 1/32 microstepping.

Texas Instruments / onsemi

LM2596 SIMPLE SWITCHER 3A Step-Down Voltage Regulator

3A step-down switching voltage regulator operating at 150 kHz switching frequency, widely available as TO-220-5 IC and adjustable DC-DC buck converter module.